水体中二甲胺的吸附与氧化降解

模拟二甲胺的水体污染,采用静态实验装置,从吸附的热力学和动力学方向,讨论活性炭对水体中二甲胺的降解情况;同时讨论了Fenton氧化-活性炭联合法降解二甲胺的效果。结果表明,活性炭吸附二甲胺是一个放热自发的过程,在常温下吸附符合Langmuir的吸附等温模型,吸附速率较慢,在90 min左右才能够达到吸附平衡,同时,溶液的pH值越大,活性炭对二甲胺的吸附作用越明显;而Fenton氧化-活性炭联合法对高浓度的二甲胺溶液降解效果明显,当按H2O2 2.4 mL/L,FeSO.47H2O 12 mg/L,活性炭0.2 g/L的比例投加药剂时,二甲胺的去除率在99%以上,溶液COD的去除率达到81.6%。     

锰铈脱硝催化剂的制备及其再生性能研究

采用等体积浸渍法制备了一系列Mn-Ce-Ox复合氧化物脱硝催化剂用于NH3选择性催化还原(NH3-SCR)NO。考察了Mn/Ce摩尔比、焙烧温度、H2O和SO2对Mn-Ce-Ox复合氧化物脱硝催化剂活性的影响及催化剂中毒再生性能。结果表明:当NH3:NO=1:1,空速为5 000 h-1,550℃焙烧制得的Mn/Ce摩尔比为5∶1的Mn-Ce-Ox复合脱硝催化剂活性最佳,活性温度窗口为100~260℃,在此温度区间内催化剂活性大于90%。200℃时,Mn-Ce-Ox复合催化剂活性最高为97.84%;在10%(V/V)H2O蒸汽和300×10-6SO2共存条件下,200℃时,催化剂活性在开始反应2.5 h内迅速下降至53%左右,并在之后的6 h内没有明显变化;中毒催化剂经常温水洗再生处理、质量分数为3%的硝酸溶液再生处理和550℃焙烧2 h再生处理后200℃活性均能恢复到90%以上,其中中毒催化剂经质量分数为3%硝酸处理后活性恢复率最高。     

pH值对纳米零价铁吸附降解2,4-二氯苯酚的影响

在不同pH条件下,对纳米铁(颗粒粒径为30～40 nm)及其降解2,4-二氯苯酚反应体系进行取样,并进行透射电子显微镜(TEM)、扫描电子显微镜-能谱联用(SEM-EDX)以及电感耦合等离子体发射光谱(ICP-OES)等形貌观测与分析表征,以考察pH值在纳米零价铁降解氯酚反应过程中的影响和作用.结果表明,在降解2,4-二氯苯酚的过程中纳米铁由分散的颗粒逐渐团聚,其表面逐渐氧化,并最终被呈针状结晶的碱式氧化亚铁(FeOOH)覆盖,从而阻碍了降解反应的进一步进行.在酸性体系中,纳米零价铁的氧化和团聚现象有所缓解,尽管会造成一部分铁量的损失,但反应产生大量的亚铁离子参与并促进了脱氯降解反应的进行,反应过程中溶液pH值有逐渐升高的趋势.不同pH条件下,纳米铁对氯酚的去除率随pH值的降低而升高,酸性条件有利于提高氯酚的还原降解速率,当pH=3时,24 h内氯酚的去除率可达到90%以上.     

不同载体材料对厌氧氨氧化效果影响的研究

文章分别采用水性聚氨酯(WPU)和活性炭2种材料作为生物载体,在2个不同的上流式厌氧污泥床(UASB)反应器中接种包埋污泥和生物活性炭,采用人工配水进行连续实验,观测厌氧氨氧化反应器启动过程中各种含氮化合物的变化,以考察不同载体材料对厌氧氨氧化过程的影响。文章在生物活性炭反应器中成功驯化了采自污水处理厂的普通厌氧污泥,证明了从环境中驯化培养厌氧氨氧化菌的可能性。通过2个阶段中脱氮效率的比较,发现以水性聚氨酯包埋材料作为未驯化细菌载体并无明显优势,反而成为传质的障碍;而采用生物活性炭则可以迅速达到提高局部生物量、聚集功能菌、屏蔽不利环境的干扰等作用,是理想的微生物载体。     

Investigation of the hydrodynamic behavior of diatom aggregates using particle image velocimetry

The hydrodynamic behavior of diatom aggregates has a significant influence on the interactions and flocculation kinetics of algae. However, characterization of the hydrodynamics of diatoms and diatom aggregates in water is rather difficult. In this laboratory study, an advanced visualization technique in particle image velocimetry (PIV) was employed to investigate the hydrodynamic properties of settling diatom aggregates. The experiments were conducted in a settling column filled with a suspension of fluorescent polymeric beads as seed tracers. A laser light sheet was generated by the PIV setup to illuminate a thin vertical planar region in the settling column, while the motions of particles were recorded by a high speed charge-coupled device (CCD) camera. This technique was able to capture the trajectories of the tracers when a diatom aggregate settled through the tracer suspension. The PIV results indicated directly the curvilinear feature of the streamlines around diatom aggregates. The rectilinear collision model largely overestimated the collision areas of the settling particles. Algae aggregates appeared to be highly porous and fractal, which allowed streamlines to penetrate into the aggregate interior. The diatom aggregates have a fluid collection efficiency of 10%-40%. The permeable feature of aggregates can significantly enhance the collisions and flocculation between the aggregates and other small particles including algal cells in water.     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

Effects of WOx modification on the activity, adsorption and redox properties of CeO2 catalyst for NOx reduction with ammonia

A series of WO₃/CeO₂ (WOx/CeO₂) catalysts were synthesized by wet impregnation of ammonium metatungstate on a CeO₂ support. The resulting solid acid catalysts were characterized by X-ray diffraction (XRD), UV-Vis spectroscopy (UV-Vis), Raman spectroscopy (Raman), in-situ Fourier transform infrared spectroscopy (in-situ FT-IR) of ammonia adsorption, NH₃-TPD, H₂ temperature-programmed reduction (H₂-TPR), NH₃/NO oxidation and activity measurements for NOx reduction by NH₃ (NH₃-SCR). The results show that polytungstate (WOx) species are the main species of tungsten oxide on the surface of ceria. The addition of tungsten oxide enhances the Brönsted acidity of ceria catalysts remarkably and decreases the amount of surface oxygen on ceria, with strong interaction between CeO₂ and WOx. As a result, the N₂ selectivity of NH₃ oxidation and NH₃-SCR at high temperatures (> 300℃) is enhanced. Therefore, a wide working temperature window in which NOx conversion exceeds 80% (NOx conversion > 80%) from 200 to 450℃, is achieved over 10 wt.% WOx/CeO₂ catalyst. A tentative model of the NH₃-SCR reaction route on WOx/CeO₂ catalysts is presented.     

华南沿海某大气背景点黑碳气溶胶污染特征

黑碳气溶胶(BC)因其显著的气候效应和对人类健康的危害而成为研究的热点。研究背景点位BC的浓度水平和来源特征有助于掌握BC在区域尺度上的辐射强迫特性和环境影响。2009年秋季在华南沿海某区域大气背景点进行了为期约40 d的BC在线观测。观测期间BC的平均浓度为(2.34±1.33)μg/m3,与其它区域背景点相比处于较高水平。利用中尺度天气研究和预报系统WRF模拟的高分辨率三维气象场数据驱动HYSPLIT-4反向轨迹模式,模拟观测期间每小时的气团轨迹,将所有轨迹分为来源特征明显的东北沿海、北方内陆、香港方向和东南海面方向四类。当受到东北沿海来源气团影响时,BC的浓度为平均水平的1.4倍,BC和CO有较好的线性相关关系,而其它三类气团影响时的BC浓度都低于平均浓度,且BC和CO的相关关系很差,说明来自东北沿海地区的较近距离区域传输是影响该背景点大气BC的主要源区。     

光氧化反应脱汞技术发展综述

燃煤电厂烟气中汞污染的控制技术研究是目前重要的环保课题之一。气相元素汞成为大气中汞污染的主要来源。文章分析了光氧化反应脱汞技术(包括光化学氧化反应和光催化氧化反应)的反应机理,认为光化学氧化反应技术脱汞均是在紫外光作用下,产生具有强氧化性的基态原子或自由基,将难以脱除的Hg0氧化为高价汞,再通过配套的电除尘器等设备将高价汞捕集,进而达到汞污染控制的目的。不同的是,在光化学氧化反应中,汞的氧化需要借助于电厂烟气中的O2、H2O等成分,而在光催化氧化反应中,反应需要在光催化剂(TiO2或TiO2负载复合物等)的催化作用下进行。阐述了光氧化反应汞脱除技术研究进展。光氧化反应脱汞技术的汞脱除率均可达到60%~70%,具备设备简单、无二次污染等优点。     

Fenton氧化对污泥脱水性能和溶解性物质作用效果的研究

研究了Fenton氧化技术在改善污泥脱水性能方面的效果,以污泥比阻和毛细吸水时间来表征污泥的脱水性能,探讨了体系的pH和反应时间对污泥脱水性能的影响以及Fenton氧化对污泥溶解性物质(SCOD+多聚糖+蛋白质)含量的影响研究表明,Fenton氧化能够明显改善污泥的脱水性能。在体系的pH=3时,反应1h后,Fenton氧化处理后污泥的CST从处理前的130.9s减少到19.7s,降幅85%;污泥SRF从处理前的3.58×108 s2/g降低到1.05×107 s2/g,降幅97%。同体系处理污泥SCOD、上清液中多聚糖和蛋白质的含量分别增加了3.7倍、2.6倍和1.5倍。